VANTEC  
 
Speed Controls R/C Set Servos Interface Videoh Audioh Other
 
   
View Cart

FUTABA RADIO SET used for add-on channels

THIS ITEM NOT ONLINENOT AVAILABLE
 
  • AVAILABLE FROM VANTEC ON 75MHz SURFACE FREQUENCIES

  • 7 PROPORTIONAL CHANNELS  +2  2-POSITION CHANNEL

  • TWO 2 AXIS JOY STICKS,  THREE  ROTARY CONTROLS,   ONE TOGGLE SWITCH

  • ASSIGN SWITCHES & STICKS to CHANNELS,  MANY PROGRAM VARIATIONS

  • ULTRA-RELIABLE Futaba PCM1024 COMMANDS VERIFIED MATHEMATICALLY BY THE RECEIVER

  • COMPLETE with TRANSMITTER, RECEIVER, NICADS, CHARGER

  • YOUR CHOICE OF FAILSAFE MODES

  • ADD 12, 16,32 or MORE CHANNELS LATER WITH VANTEC KEYKODER

 

Futaba makes more Radio Control Systems than anyone worldwide.  Their PCM 1024 systems offer the best combination of command integrity and servo update rate compared to any system manufactured today.  Those reasons are why VANTEC choose to base their KeyKoder channel expansion systems on the FP-9CAP 9 channel radio set that incorporates Futaba's superb PCM1024 technology. The Pulse Code Modulation receiver is smart; it contains a microprocessor. By clever mathematical structuring of the servo commands  PCM1024 facilitates accurate reception even with severe noise or interference. No more servo jitters! For the technically inclined see The PCM Advantage.

Futaba's PCM1024 scheme gives 8 channels of 10 bit resolution.  Channels 1-4 and 6-8 are fully proportional giving over 1000 transmitted servo positions each.  Channel 5 is commanded by a toggle switch on the FP-9CAP thus reducing that channel to a two-position servo command.   There is an additional 2 position channel.  Dual rates, exponential, mixing and many other combinations are easily programmable.  However, if you prefer simple basic operation just reset the program to the basic factory defaults.

Vantec carefully retunes these radios with a spectrum analyzer in compliance with FCC regulations to operate on particular 75 MHz surface frequencies so robot builders and boating enthusiasts can enjoy multi-channel operation of their vehicles. They are backed by a limited one-year warranty based upon a nominal repair charge for units not tampered with or abused. Details available on our Warranty page.

Note: Our products are not safety devices nor for use in life-critical or life support systems. Specifications and price subject to change without notice. Patented. Some trade names, trademarks & content owned by others.

   
Sales: (800) 882-6832

 Home Page

Contact Us

Copyright 1998-2011 VANTEC, All Rights Reserved
460 Honeycutt Dr.  Grants Pass, OR 97526
 Switchboard: (541) 471-7135
FAX: (541) 474-3987 
Enable JAVASCRIPT for best performance

 
Application Help Terms and Conditions Home Browse Catalog Testimonials Affiliates Manuals Repairs About Us Contact Us Top of Page Speed Controls R C Sets Servos Interface Videoh Audioh Other