Speed Controls R/C Set Servos Interface Videoh Audioh Other
 
   
View Cart

   

Selection Guide


 This Selection Guide steps are:
       1.  Learning about  your motors by
             a.  Manufacturer model number, OR
             b. Continuous running current ratings under your average mechanical load at a known voltage, OR
             c. Armature resistance from "D" cell test 
       2.   Total motors per robot
            a. Two - one motor per side
            b. Four - two motors per side
                 1. Each pair wired in series
                 2. Each pair wired in parallel
            c. Six - three motors per side
      3.   Tell us your intended motor operating voltage which  may be higher than specs to push competitive performance. 
            We  then  translate that into battery voltage considering Series vs Parallel wiring, and suggested speed control.

 

Step 1: 
 
Return to the Combat 'Bot Selection Guide
 

Contact Us

Copyright 1998-2011 VANTEC, All Rights Reserved
460 Honeycutt Dr.  Grants Pass, OR 97526
 Switchboard: (541) 471-7135
FAX: (541) 474-3987 
Enable JAVASCRIPT for best performance